1. The tolerance given for the ID is +/-0.002, which suggests that, at the minimum allowable dimension, the 0.143 pin will not pass. The note...
Gravity is very real and very much a part of a complete analysis. If you want a valid analysis, you MUST consider gravity.
Kevin- this has been an idea I have had with another forum in which I participate- certain topics/questions come up frequently, and one encounters...
One of the things that I have maintained for years about engineering education is that the most important thing one learns in engineering school...
You should begin by having a look at Engineering ToolBox (http://www.engineeringtoolbox.com/) for something similar to what you are describing....
My latest project is the 3D printer I just built. Lots of tweaking and testing so far- great fun. Not likely to be a revenue source any time...
As an engineer with many, many years of practical experience under my belt, I STILL have difficulty describing to the uninitiated just exactly...
It appears you are using the wrong pivot point. It appears that the actual pivot point will be the center of the support shaft. It also appears...
You might find what you are looking for here.
Actually, for learning purposes, Dassault Systemès offer DraftSight2 for free. A good, entry level tool for getting to know the Solidworks/Catia...
srdfmc- Yes- CAELinux can run in a virtual machine (if the virtual machine is 64 bit- all the latest versions of CAELinux are 64 bit. You have to...
I have not actually addressed the problem you are considering, but you may want to have a look at some of the packages included in the OpenSource...
Separate names with a comma.
▲
