• Welcome to engineeringclicks.com

    • Recent Content by Gilles

    1. Gilles
      Post

      Molded tube and draft

      Thanks for all your answers :) The Ø are shown in the picture :). The plastic tube ID is 6mm OD is 8mm. The length of the plastic tube is 40mm....
      Post by: Gilles, Mar 23, 2017 in forum: The main mechanical design forum
    2. Gilles
      Post

      Molded tube and draft

      In fact what I really need is to have the center axis of the carbon shaft and the palstic tube aligned. A deviation of .1 mm is acceptable. Epoxy...
      Post by: Gilles, Mar 22, 2017 in forum: The main mechanical design forum
    3. Gilles
      Post

      I have 2 PCBAs that are connected by a long innerly-threaded spacer

      Might not be perfect solution but : Could you used less rigid spacer? For example palstic spacer instead of steel ? So they could be bent a bit at...
      Post by: Gilles, Mar 21, 2017 in forum: The main mechanical design forum
    4. Gilles
      Thread

      Molded tube and draft

      Hi everyone, I have to design a plastic tube that will be glued on a carbon tube. The assembly will then be fitted into an aluminium hub in which...
      Thread by: Gilles, Mar 21, 2017, 7 replies, in forum: The main mechanical design forum

    ▲

    1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies.
      Accept Learn More.
      Dismiss Notice