its also used in extensible clamps, and in pipe clamps. The analysis is similar to the analysis used to determine the maximum overhang of a load...
typically that is done as "4x dia .025" or "dia2.5 4 plcs" but yes, I am pretty sure it means four places.
maybe vapor pressure? that is something that I always notice - gas cars have a "whoosh" when the tank is opened, but diesel does not.
crappy engines still run. You can build a running Stirling engine from soda cans, balloons, coat hangers, and JB weld. You would never...
I think a single piston and a custom cam is a very nice solution to this. you may have to make some trade-offs between good cam design and flow...
Cast iron is not really practical. 2mm is a little thin, the parts are small, and it can be done just as better with other materials. why are...
a thin rubbery coating is even better than powdercoat.
Most cities have a metal supply place or a scrap metal place. or a sheet metal shop could let you have some scraps. Looking at your tiles, the...
400 series stainless is magnetic, 300 series generally is not. Stainless is more expensive than a plain steel, but if you powdercoat the plain...
probably. yes the brown parts should be stronger. the loads will very depending on the shape of the cam and the speed at which it is turning....
The yellow rollers that run on the cam and reset the arms are just standard roller bearing cam followers. Get ones that aren't sealed, or take...
Like KISS said find a small motor and gear it down. However gearing to a lower speed does not increase power, it does increase torque. power is...
rubber plaster molding is a very good way. The alloys used for casting are closer to die cast alloys than the alloys you would use for a machined...
"in theory there is no difference between theory and practice, but in practice there is" This is Erich's quote, I was quoting it back to him....
Increase motor efficiency? not necessarily. the motor is being assisted by something external (to the motor) and so it will shift to a different...
Separate names with a comma.
▲
