• Welcome to engineeringclicks.com
  • Rotary Table Calculation

    Discussion in 'Calculations' started by Rudra, Jan 5, 2017.

    1. Rudra

      Rudra New Member

      Jan 2017
      Likes Received:
      Namaskar everyone,
      Firstly , I am new to forum platform so if any mistake plz guide .Want to discuss(know) on calculation related to rotary table drive. Below are my queries
      How to calculate torque required to rotate a round table round its own vertical axis , with a mass load of 400 kgs & table load (self weight) of 50 kgs with a dia of 500 mm center support on thrust cum radial bearing & drive given through a pinion of dia 75 mm to a gear of dia 400 mm attached to bottom of table with same table center . I want to know what torque will be needed at 75 mm dia pinion.
      Note : Dia mention are pitch dia of gears & pinion drive big gear internal .
    3. Dana

      Dana Well-Known Member

      Sep 2010
      Likes Received:
      Impossible to answer without knowing the bearing friction and how fast you want to accelerate / decelerate it.

    Share This Page

    1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies.
      Dismiss Notice