• Welcome to engineeringclicks.com
  • the conic in sketcher of Solidworks and Creo 3.0

    Discussion in 'Creo or Pro/Engineer' started by design-engine, Feb 27, 2016.

    1. design-engine

      design-engine Member

      Jun 2012
      Likes Received:

      Any math nerds? I posted this image on twitter today as part of my Creo surfacing workshop exlanation to explain the difference between ellipse and hyperbola. Thought it might be a good thread to start about the strengths of the y=x^2 type of conic tool that now resides in Solidworks (finally after 15 years of asking)

      What are the strengths or pros to this sketcher tool?

    Share This Page

    1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies.
      Dismiss Notice