• Welcome to engineeringclicks.com
  • Timing belt calculation

    Discussion in 'Calculations' started by mindoverflow, Jun 25, 2015.

    1. mindoverflow

      mindoverflow New Member

      Jun 2015
      Likes Received:
      I would like to know what's the adviced width for a timing belt on a gantry table for linear transmition, the used motor is rated at a torque of 12 NM that would be placed on a 3:1 gear. I know that it will depend on the material of timing belt and manufactuerer, but I would like to know your advice or an approximative value and how you calculate it, also what's the adviced material.

      I think about 4cm T5 PU steel reinforced timing belt, would it fit.


    Share This Page

    1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies.
      Dismiss Notice